Lace frontal modules are currently a popular choice due to their versatility and natural appearance. Wefted extensions from the nape to the crown and hand-knotted lace in the frontal area, with lace from ear to ear, are used to create these wigs. Hair strands are knotted all over the wig cap to completely cover the head and can be worn in a variety of styles.
Read also: How To Care And Revive Old Wig
These are more expensive than lace closure wigs since they require longer to create. It is, nonetheless, the most versatile wig. A comfortable, natural new look and style can be achieved by properly putting on a wig.
How to install a frontal
Ensure to wash your scalp proper with shampoo and warm water to remove oil from the area
Apply adhesive to the locations where the wig will go. Blow-dry the adhesive for around 30 seconds using the warm-cool air setting.
Repeat the process three times more, leaving the glue slightly sticky and transparent.
Place the front section of the wig on your forehead and push firmly for at least 60 seconds with both hands.
Press hard for another minute after attaching the sides to the matching regions on your head.
Trimming the lace on a lace frontal wig is only necessary the first time you use it; if the lace has previously been trimmed by the manufacturer, it is not required.
Place the wig on your head to trim the lace. To keep the wig hair away from your scalp line, use hair clips.
Using a pair of sharp scissors, trim any lace that hangs out past the wig hairline. To avoid mistakenly cutting too much lace, cut modest quantities at a time. Make sure you don’t cut any of the wig’s hair. Lace can be re-worn after it has been cut.
Remove body oils and additional adhesive from the skin near your hairline with isopropyl alcohol to prevent the wig glue from sticking correctly and turning white.
Apply your favourite edge control product or gel with your fingers to lay down your edges to perfection.
Apply a thin coating of adhesive glue to the entire hairline with a small makeup brush or cosmetic stick if using adhesive.
If you’re using a gentle bond adhesive, don’t put the wig on right away. Wait until the adhesive has hardened into a sticky state. If you choose a hard bond adhesive, the wig may be put on right away because it adheres quickly.
Use the wig combs to fix the wig part to your hair in the correct position. Make sure you’re not pulling too hard, as this can produce rippling!
The lace frontal is being placed on your head. Parting the wig’s hair is the quickest technique to find the wig’s front centre.
The hairline can be seen by parting the hair. At your hairline, the middle of the wig hairline should line up with the middle of your forehead.
Those using glue to secure a wig should begin by securing the wig at the hairline at the front centre of the forehead.
Gently press the wig’s edge against the glued skin, working your way around the hairline until it’s completely attached.
Pull the wig down and make any required adjustments. Flat ironing the top might assist to smooth it down and making it look like your hair.
To make the glue cling to your skin, press down on the wig’s edges for five seconds. As desired, style the wig.
Read also: Wig To Choose From In 2022 Lace frontal or lace closure